Take the 2-minute tour ×
Music: Practice & Theory Stack Exchange is a question and answer site for musicians, students, and enthusiasts. It's 100% free, no registration required.

Generally audio interface line out is connected to studio monintor speakers. Since i don't have any i was wondering i could use my marshall 15watt guitar amp as speakers.

if i connect audio interface line out to guitar amplifier guitar input ( 1/4" ) can it damage the audio interface.

audio interface part http://www.image-share.com/upload/2230/284.png

guitar amp part http://www.image-share.com/upload/2230/283.jpg

share|improve this question

3 Answers 3

up vote 1 down vote accepted

I would say the one that can be damaged is the Amp. The signal coming out of the Focusrite is stronger signal than the guitar normally output, so the Marshal Amp might receive a signal that is too strong.

If you are careful starting with low volumes you will not have problems, still give low signal from Audio Interface and always check the volume is not distorted or too strong.

The Focusrite has a output Impedance under 10Ω, check the input impedance of your Marshal.

Anyway you are listening in mono, I would suggest headphones instead if you cannot afford studio monitors. The AKG 240 are known studio headphones.

share|improve this answer
thanks, and like i asked to above answer. will any other cheaper substitute like speaker woofer etc. work ? –  silverkid Jul 27 '13 at 8:09
@silverkid, It's always good to have different listening in a studio. I have Genelec 3040, plus 2 different headphones, plus a 2.1 "typical computer speakers" because I know my music will be heard in different speakers. I think a 2.1 cheaper system is good to have, start there! It's anyway better than a mono signal in a Marshal amp. –  Sergio Jul 27 '13 at 8:20
Just for the record, since I can't edit my post I meant Genelec 8040... –  Sergio Jul 27 '13 at 10:13
ok thanks again –  silverkid Jul 27 '13 at 11:51

It is more like to damage the amplifier. The amplifier is designed to take instrument level signals, which are much lower in power than line level.

However solid state amps are pretty hardy. If you turn the volume right down on the PC, it should work. You won't get the greatest sound quality.

share|improve this answer
thanks, How to get great sound quality then without studio monitor speakers ? Do home music systems or 2.1 ( 2 speaker 1 woofer ) kind of stuff help me get a good sound quality ? Basically I am asking this because i have found studio monitor speakers are expensive compared to these alternatives –  silverkid Jul 27 '13 at 8:00
Without getting too technical -- "studio monitor speakers" are just a fancy expensive version of a home hi-fi. –  slim Jul 31 '13 at 15:38

You're almost bound to make distorted noise. Going through a guitar amp. will give you mono, not stereo, so sound quality will not be as good.

Using a decent pair of headphones is the pro. way to go anyway.

Plugging into the 'aux' of a decent hi-fi set up will give a good sound, if you can attenuate the input signal.

You're more likely to damage the speaker of the guitar amp by pushing an overloaded signal through it.

You could maybe plug into the 'return' socket of a guitar amp.

share|improve this answer

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.