Take the 2-minute tour ×
Musical Practice & Performance Stack Exchange is a question and answer site for musicians, students, and enthusiasts. It's 100% free, no registration required.

I learned Overworld Theme 2 from Super Mario Bros. 3 a few years ago, which features the nice bright high notes of A6, G6, and F6:

sheet music

I noticed on my 80 year old upright piano that the A and G rang out almost as if I was holding the pedal (they just die a bit quicker), whereas the F did not. Upon experimenting I found that F#6 and any higher note rang like this. I thought maybe this was just peculiar to the acoustics of my piano but I recently got an electric piano that emulates a modern grand, and it does the same thing! Why is this?

share|improve this question
add comment

4 Answers 4

As others have mentioned, those strings do not have dampers (the felt things that mute a note when you release the key). The reasoning is several-fold.

First, the higher notes have much less sustain than lower notes. The dampers wouldn't really have much effect since those notes die out so quickly.

Second, undamped strings are free to vibrate complementarily with other lower notes played on the piano (this is called sympathetic resonance). By leaving the top notes undamped, they are free to add depth and brilliance to other notes played.

As a side note, this is why a single note played with the damper pedal down sounds so much more full than with just the note held down - the other strings resonate with the original note played. Try it some time! Push the damper pedal and play (and hold!) a single note. Then, without releasing the key, let the pedal out. You'll hear how much sound goes away!

share|improve this answer
1  
+1 Welcome to the site! –  luser droog Jan 29 '13 at 1:17
add comment

If one strikes a note (say C3--an octave below middle C) on an acoustic piano without the damper pedal and then with it, one will likely notice that the second note sounds slightly different--probably brighter. This is because the struck string will vibrate with energy not only at the frequency of C3, but also some other frequencies including C4, G4, C5, E5, G5, and C6. If the strings corresponding to those other frequencies are not damped, some of the energy at those frequencies will transfer to those strings, causing them to resonate along with the string that was struck.

If all one ever wanted to do on a piano was play notes that would sustain as long as the strings allowed, having all of the strings undamped would probably improve the sound. A lot of music, however, requires that notes not sound for anything near the durations achieved by the lower strings on a piano. Consequently, the lower strings need dampers to avoid allowing music to be played at a reasonable speed without turning into mud. The upper strings on a piano have a natural decay rate which is much faster than that of the lower strings; additionally, their higher natural frequencies may allow them to add more brightness than would the lower strings. These two facts together have led piano makers to omit dampers from the upper strings (the fact that such omission saves cost probably contributes to that decision, but even expensive pianos generally omit the dampers).

share|improve this answer
    
The overtones are present regardless of whether or not the damper is used. –  Tony Jan 28 '13 at 18:49
1  
@Tony: They will be present in the struck string regardless, but dampers will affect the ways in which their energy gets distributed between strings, the sounding board, and the air. If one presses and holds G4, waits for the sound to die out, and (while still holding G4), one presses C3 (about 1.5 octaves below), the overtones from C3 will likely start G4 vibrating. As long as C3 is playing, G4 won't be very audible, but if one releases C3 it will be possible to hear G4 ringing, and that ringing will stop if G4 is released. –  supercat Jan 29 '13 at 0:16
    
Thank you for your clarification. I think I just misinterpreted/misread what you had originally said. –  Tony Jan 29 '13 at 16:23
add comment

Look inside the piano: there are no dampers for the highest notes. I don't really know why; maybe it's for some extra resonance (both for the high notes and in general).

share|improve this answer
    
I have noticed this too. Anyone have any idea as to why? –  Simon Jan 28 '13 at 17:37
    
The higher notes don't have as long of a sustain and whoever designed the piano probably thought it was fine to leave them off. –  Tony Jan 28 '13 at 18:43
add comment

I'm not 100% sure this is the reason, but it is something I noticed about the guts of a piano. I no longer have a piano available to check, but I'll stick my observations in here anyway. :)

At some point around the 2/3 point of the range of the piano, strings go from (mostly) wound to (mostly) plain. Plain strings tend to ring more, like you describe. Wound strings have more sustain (Due to more mass?).

Take a look at this image: Piano Guts

Notice the nearly vertical bar about 2/3 of the way over? From that point, at least on my former piano, the strings went from wound to having some wound and some plain strings.

Here's an image of a wound string: Wound String

And here's a plain (guitar) string: Plain String

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.