The amplifiers tag has no wiki summary.
1
vote
2answers
107 views
How to modify Trace-Elliot Velocette amp to make it more suitable for use with bass?
I have a Trace-Elliot Velocette that I'm very satisfied with. This amp works very good also for recording bass, but the low notes will be much less sturdy when recording through this amp than if I ...
4
votes
2answers
65 views
Switching amp heads with pedal
I was listening to Killswitch Engage and decided to look Adam D's rig up. He's used multiple amps and guitars, but is sparse with pedals. When reading this I started wondering how they achieve cleans ...
1
vote
1answer
59 views
How important is a good amp? [closed]
I always wanted to know the importance of a good amp for a guitar.
Do I rather need a 50w tube amplifier that sounds like heaven, or is it already enough if I get a good pedal? Or do I need both?
I ...
1
vote
1answer
57 views
How to choose a good pedal for my guitar [closed]
I've played the guitar for almost 8 years and I use an amp since 2 years (since I've started with the electric guitar).
My amp is the Nux Mighty 15 DFX.
I really enjoy playing and I also have recorded ...
1
vote
3answers
79 views
Speaker clipping when bass guitar controls turned up, but not when amplifier controls turned up to same volume
I've noticed if I have my bass guitar's volume and bass EQ knobs turned all the way up, it sounds like the speaker is clipping. If I then turn the volume and bass down on the guitar while turning the ...
0
votes
3answers
186 views
Amplifier has no aux in, what alternatives can I use?
As stated my amplifier has no Aux in jack. It's hindering me from practicing with an otherwise (imo) great amp (a Vox Pathfinder 15r).
Been thinking of using this to interface between the music ...
4
votes
5answers
2k views
What's the best choice to get more juice out of a tube-amplifier.
The story behind this question:
I got myself a nice little combo for my bedroom-workouts (related to playing guitar, of course :D ), a Blackstar HT1-R which is a lovely little 1 watt 2 channel ...
2
votes
2answers
50 views
Distortion effects pedal to amp
I have a blackstar ht-5r combo amp..... Would I get a clearer sound using the effects loop with my distortion effects pedal compared to plugging pedal into front amp input then using clean channel? ...
0
votes
1answer
68 views
No sound plugging effects pedal into combo amp
I tried to use my distortion effects pedal through the guitar input of my combo amp, and I get no sound!
I used it in effects loop and worked fine and amp works fine when guitar is plugged straight ...
3
votes
2answers
288 views
Valve and solid state guitar amp power comparisons?
is there a chart or general rule of thumb of how the different power levels for a valve amp compare to an equivalent volume solid state amp?
for example,
5 watt valve amp similar volume to 20 watt ...
2
votes
4answers
304 views
Can you use any footswitch on any amplifier?
For example, if I have an amplifier that comes with a 4-button footswitch (2 cables for this footswitch), can I use just any footswitch in the store with 2 buttons (1 cable) and just plug 2 2-button ...
5
votes
4answers
416 views
Why does my guitar sound more natural when plugged directly into a tube amp vs through a pedal board?
Why does my guitar sound better when plugged straight in to my amplifier as opposed to running it through a pedalboard without a true bypass strip?
11
votes
7answers
2k views
How do you mic a guitar amp?
How do you go about mic'ing a guitar amp for live performance? Would you do anything different if you were mic'ing the amp for studio recording? Is there anything specific I should look for in a ...
10
votes
3answers
10k views
Do distortion pedals work well with tube amps? Or should I use a tube screamer?
I have a Blackstar HT5 tube amp and I like to use a Boss DS1 with the clean channel for the heavy stuff (Zeppelin to Nirvana, these are very different I know). Is this considered a good idea, or ...
10
votes
4answers
811 views
Valve (tube) amps and clean tone
Is there any difference in clean tone sound between a valve/tube amp and a solid state amp? i.e., does having a valve in an amp affect the clean channel, or only the distorted channel?
Apologies for ...
6
votes
3answers
4k views
guitar cabinet: why not just use a PA speaker cabinet?
I've been thinking about building myself a rackmount rig to replace an old 12" combo amp, and was wondering if it really makes any difference to use a something that's marketed as a "guitar" speaker ...
13
votes
3answers
418 views
When should I be concerned about calibrating the bias of vacuum tubes in an amplifier?
I think it would be useful to discuss the concept of bias as it pertains to guitar amplifiers. I have read some articles saying that you should always rebias your amplifier when you change the power ...
6
votes
3answers
439 views
What should I look for in a ukulele amp
I bought an electric ukulele and now I need an amp for it. What should I be looking for? Is there any uke specific things that are particular to this kind of amp? Would a regular guitar amp work just ...
0
votes
3answers
958 views
Can I use a Line6 Spider combo amp as a cabinet?
I just purchased a tube amp head (Peavey Windsor). I don't currently have the funds for a proper cabinet, so I was considering rewiring my Line6 Spider 212 combo amp to behave as a 2x12 cabinet.
It ...
0
votes
0answers
38 views
Solid state amplification milestones [closed]
I'm trying to find information on solid state amplification development. Can anyone help me?
3
votes
3answers
91 views
Buying a guitar amplifier from another country
A while back (before stackexchange) I read that it's not recommended to buy an amplifier from a country with different electricity (110v 50hz vs 220 60hz) because the circuits will create a different ...
5
votes
5answers
424 views
How do I get pinch harmonics during solos?
Could someone tell me how to get the pinch harmonics sound during solos? Specifically on the "Wanted Dead or Alive" solo by Bon Jovi?
Is it an amp setting? Is it something I do with my left or right ...
0
votes
2answers
213 views
Can I connect an amplifier head to the top of my existing amp?
I have a HIWATT G50MR and have thought about buying a stack, but I was wondering if I could just buy a amplifier head and connect it to the top of my existing amp. Is this possible?
5
votes
2answers
2k views
Recording an amp using headphone out?
I got an Peavey Vypyr 30w. There is a headphone/record out.
Since I do not have a mic currently,
I want to utilize it for recording, what devices do I need?
I know there is some electrical ...
6
votes
3answers
4k views
Do phase inverter tubes effect the sound of my amp?
I was told once that a phase inverter tube should "just work" and that it has no effect whatsoever on the tone of the amplifier. Is this true?
6
votes
8answers
414 views
What are the advantages of point to point (PTP) wiring?
What are the advantages of having a pedal or amp that is point to point wired as opposed to one that is built on top of a printed circuit board? Are there any disadvantages of PTP?
2
votes
2answers
1k views
150w 8ohm speaker on 300w 4ohm channel - have I done my maths right?
I'm building a DIY frankenamp.
It currently consists of a speaker cab with a 15 inch, 150w @ 8ohms celestion truvox red label, which is plugged into one channel of a Skytec pro600 stereo power amp.
...
3
votes
1answer
272 views
Tube screamer 808 with an ENGL Screamer 50W amp
As an Andy Timmon's huge fan I try to get my guitar tone to sound similar to his. In one of his videos I saw that he uses the Ibanez ts808 tube screamer pedal.
I own an ENGL 50W screamer amp which ...
1
vote
2answers
137 views
ENGL Screamer Tubes
I recently bought an ENGLScreamer 50W combo and I noticed that only two tubes (out of the six) are lit (the two big front ones if you look from the back). From the manual (page 5 at the bottom) I see ...
0
votes
0answers
72 views
distortion for a tube amp [closed]
i have a marshall ma 100 1/2 stack the high gain is just soso what distortion pedal would be the best for this amp I currently run a digetch rp 355 or my rp 500 through the clean channel
4
votes
1answer
205 views
How should I connect my compressor effect to my amplifier?
Just bought an ENGL screamer 50W amplifier and the only thing I miss right now is a decent compressor for the clean channel.
I also have a Zoom g9.2tt effects device and I was thinking of connecting ...
0
votes
2answers
399 views
Effects of keeping an amplifier in the car
While it seems like it's probably best not to expose anything to extreme climates, will keeping a guitar/bass amplifier in a car for a day, in either hot or cold climates, have any short-term effects ...
0
votes
2answers
270 views
2 Heads on one Cab?
I have two Half stacks, one Marshall and one Kustom. My question is can I plug the two heads into each cab?
What I want to end up doing is have an ABY switch from my guitar straight to the Marshall ...
6
votes
4answers
940 views
How to predict the loudness of an amp based on description
Related question: Is there an amp power formula?
When I look at amps in a shop or online, I ask myself what the amp is suitable for:
Can it be played quietly enough for home use without disturbing ...
2
votes
3answers
76 views
Information about selling my guitars [duplicate]
Possible Duplicate:
How do I assess the value of a guitar when I'm preparing to sell it?
So I have three guitars that I want to sell. After this, I want to buy a pretty nice acoustic to ...
1
vote
1answer
3k views
How do preamps and power amps compliment/replace guitar amplifier heads and combos?
I see rack mounted power amps and preamps, mainly for large venues. But I don't know exactly what they do.
I know a preamp can be used to boost a microphone signal for a soundcard, but I don't know ...
1
vote
3answers
2k views
Turning off my monitors makes loud popping noise
I've been told that my turning down the channels on my mixer before turning off my monitors, I can prevent the loud popping noise they make, which will damage the speakers in the long run.
However, I ...
0
votes
1answer
1k views
How can I recreate Alex Kapranos's sound (Franz Ferdinand singer and guitarist)?
We're preparing a Franz Ferdinand coverband and I would like to get as close as possible to Alex Kapranos's instruments' look & sound. What do I need to do this?
For the look I'll need a Fender ...
3
votes
1answer
123 views
Is there an amp power formula?
I'm looking to buy a new amp for my keyboards, and I was wondering if there's a formula I can use to help me calculate some of the objective specs I should look for. Something along the lines of: I ...
4
votes
5answers
1k views
Using an electric bass guitar with a guitar amp / hi-fi system?
I understand that you should use an amp that was meant to be used with your instrument, but sometimes maybe you just don't have the money, or your amp is not around when you need it, or for whatever ...
5
votes
2answers
271 views
What makes an amp sound heavy?
What I want to know is what makes some amps sound the way they sound like the Sunn Model T/Sunn Scepter or the Ampeg VT22. What are the components inside the amps which give it a round, fat , heavy, ...
4
votes
5answers
254 views
Is it necessary to play a keyboard amp before buying
I have always stood by "try before you buy." However, my little brother believes he doesn't need to try out a keyboard amp before he buys it, because the EQ is much flatter.
His claim is that the ...
1
vote
1answer
600 views
How can I connect speakers to my POD 2.0 and get a good sound?
I like to practice at home with my electric guitar, but I have to keep the volume low, so I usually use headphones connected to my P.O.D. 2.0 guitar direct box. But sometimes I'd prefer to use ...
9
votes
4answers
5k views
Difference between “hi” and “low” on amps?
What is the difference between "hi" and "low" input jacks on guitar / bass amps? Usually bigger amps have both of them (didn't see them on smaller ones really)..
2
votes
1answer
184 views
Bolt 100 watt amp making a phaser noise
My Bolt amp is making this wierd noise. Sounds like a flanger or phaser when pushed hard with my OD pedals. I have never heard this noise before in any amp.
Could it be the Phase Inverter tube? The ...
1
vote
1answer
446 views
Using a looper live - how to connect playback and overdub to 2 different amps?
I currently bought a Boss RC-2 Loop station because I want to play the second guitar in my band as well. My problem now is that I don't want the two guitar tracks - playback and overdub - to come from ...
3
votes
5answers
2k views
Choosing a guitar cabinet
I have settled on the amplifier head to buy for my guitar, but I am not sure of the cabinet yet.
I know that there are open-back vs closed-back options, and I assume that the quality of the speaker ...
7
votes
5answers
1k views
Guitar Amplifier (Head versus Combo versus None)
I'm in the process of getting my first electric guitar and am trying to figure out amplifiers. I currently have a stereo amplifier and pre amplifier and a pair floor standing speakers. My living space ...
4
votes
5answers
192 views
Save money when buying a guitar / amp?
I want to buy an electric guitar and amp.
I found that
there is a good buying guide in this question.
But in terms of budget,
seems that there is not much discount / deal for musical instruments
...
5
votes
4answers
613 views
Bad sound from amp
I get this really bad feedback sounding noise when I play stuff like this, from the beginning of the Free Bird solo,
shown in tab:
1 ----18---18---18---------
2 -18---18---18---------
(All notes ...
