Keeping an instrument in playable condition.

learn more… | top users | synonyms

7
votes
2answers
122 views

cleaning trombone slide where outer slide is under the inner slide

I have been playing for some time, but have never found a good way to clean the inner slide up inside the part where the outer slide is under the metal in first position I've tried tooth picks and ...
6
votes
2answers
573 views

What purpose does adjusting the violin bow tension serve?

A violin bow has a screw that allows you to adjust the hairs' tension. Like a tuning peg so to speak. When I just got mine, I didn't pay attention to it. I worked with the tuning pegs because I knew ...
6
votes
5answers
696 views

What am I doing wrong when tuning the violin using a web application?

I don't know anything about violins, and I won't have time for a tutor until much later. When attempting to tune my violin, I was advised to get a digital violin tuner. Alright. But before I go get ...
10
votes
3answers
2k views

What should I consider when I see a loosen hair in a violin bow?

This drawing should do: These are the hairs of a brand new bow. Straight, clean, etc. I noticed this: As you can see, it seems like a certain hair is a bit loose. Is this wrong? (affects ...
5
votes
2answers
307 views

Effect of Rubbing Alcohol Upon Reeds

Apparently it is common to briefly soak reeds in rubbing alcohol to disinfect them. This could be due to sickness, reed-sharing, etc. Any thoughts on how damaging this would be to the cane?
3
votes
1answer
221 views

Is there any PC software that I can use to help edit Roland RD700NX sets/perform maintenance?

I've just downloaded the V2 software for my RD 700NX and see the RD-NX Editor seems to only work on the iPad. I've searched and can't find anything, but does anyone know of any way to edit my ...
3
votes
3answers
1k views

What is the best way to remove a broken bridge pin?

I decided to give my guitar a well deserved clean, but when I came to remove the low E string, the bridge pin was a bit stuck so I resorted to using pliers, which turns out to have been a very bad ...
5
votes
3answers
1k views

Saxophone sometimes out of tune by nearly a fourth

Our band's saxophonist has a bizzare intermittent fault with his soprano sax (so normally uses his tenor or alto sax). Sometimes it's fine and sings beautifully, but other times it'll be out of tune ...
1
vote
1answer
81 views

Adding a new pot to my guitar

I am willing to add another tone potentiometer to my guitar and I wanted to know what is the best way to add a hole in the pickguard for the new pot. Is there a dedicated tool for this task? What is ...
8
votes
2answers
1k views

Right way of resting a guitar

While not using or after using, what is the right way of resting a guitar. If I lean it towards a wall, is it right to lean it with the strings facing the walls or otherwise? Is it fine to hang the ...
3
votes
1answer
1k views

Acoustic guitar damaged by impact. How to repair?

Introduction My acoustic guitar has suffered damage at four locations. It still sounds very good, and it is more than twenty years old. The damage done The different damage locations are pictured ...
5
votes
1answer
401 views

Can playing in cold weather damage a drum set / skins?

My set is in the garage, and now that it's winter, temperatures have been between 10 C and -10 C (50 F and 14 F). Is it OK to play the drums at such low temperatures, or will it cause damage to the ...
12
votes
3answers
3k views

How does the piano middle pedal work? Is there a standard symbol for it?

What are the mechanics behind the middle piano pedal? I have been using the middle pedal for a variety of music, it is wonderful, but I can't figure out how it works (I mean the mechanical process). ...
1
vote
2answers
759 views

How do I figure out whether my guitar tuning machine heads are failing on me?

What are the symptoms of low quality guitar machine heads? I know it can be the nut that's causing the problem, but besides that, how can I know whether changing the machine heads will help my guitar ...
1
vote
1answer
1k views

Remove Mouthpiece Tarnish

I have a fifty year old F.E. Olds & Sons Ambassador cornet. It lay unused for 30+ years (it is now oiled and greased properly). There is considerable tarnish on the mouthpiece and on the slides. ...
6
votes
3answers
2k views

How do I clean the windway on my recorder?

I have a plastic soprano recorder about ten years old. Over the years its accumulated some dirt or something in the windway. it has a straight windway. What is the best way to clean it out? Could any ...
3
votes
1answer
122 views

Should I take the weather into account when I replace guitar strings?

I have been told that the strings in a guitar should be replaced at least every six months (I know this can be subjective). I have a classical guitar which has been several years with the same ...
1
vote
1answer
385 views

Cleaning a harmonica with a blocked note

I have a harmonica which was given to be as a gift, I have no proper experience playing and maintaining a harmonica, nor do I still have the instructions. I could blow all 9 notes but the 10th. When I ...
2
votes
2answers
1k views

Voice trills unintentionally when singing high-pitched notes

I'm not an experienced singer, so I suppose I've got plenty of knowledge missing when it comes to keeping my voice in shape. Whenever I try to sing a high-pitched note, my voice inadvertently starts ...
3
votes
11answers
7k views

Strange guitar warble sound

I have a Jackson Dinky DK2M with two Seymour Duncan Humbucker pickups and a floyd rose tremolo on it. It is producing a strange `warble' noise on G string, especially on higher frets like 12th, 15th, ...
7
votes
2answers
1k views

Adjusting clarinet or saxophone reeds

How do various techniques and equipments for adjusting reeds compare? e.g. ...
4
votes
2answers
559 views

Acoustic guitar, chip in rosette wood, how to avoid in future?

I was performing this afternoon when I felt a sharp pain in my right thumb. I looked down, and there was a big hunk of wood (about half an inch long) sticking out from my right thumbnail. There was a ...
5
votes
4answers
5k views

Best method to clean guitar?

After a month or two of playing, the strings will often have grime and skin oil stuck to the underside, and the frets will eventually start building up dirt. Add to that all the dust that accumulates ...
5
votes
2answers
205 views

Keyboard keys failing.

I have a Roland EM-1B and some keys are failing... I disassembled it, and the sensors are working correctly, even with velocity. If I press them directly with my fingers they work, also in locations ...
12
votes
2answers
7k views

Cleaning a tarnished flute

My flute is tarnished and needs to be cleaned... I was afraid if I polished it, I would break something on it. I read online that it's a bad idea to remove tarnish on a flute yourself as you can ruin ...
7
votes
4answers
2k views

Is grease good or bad for guitar strings?

I was once told that playing a guitar with greasy fingers was actually good for the strings. However, this seems a bit counter-intuitive. Is there any truth behind this claim?
10
votes
3answers
3k views

How to remove all traces of rosin from a bow ?

I saw once the case of a beginner violinist that turned out to be allergic to a specific type of rosin that came with his student violin outfit. Another hypoallergenic rosin was purchased and they ...
11
votes
3answers
896 views

Will my wind instrument be damaged if I leave it assembled?

Almost every teacher, expert, and book has informed me that I should disassemble my (clarinet / recorder / saxophone) each time after I practice. However, it is difficult for me to see how this would ...
7
votes
1answer
298 views

Is there a standard efficient method of cleaning / maintaining a guitar?

In terms of 'spring-cleaning' and maintaining guitars, and asking with regards to those of the acoustic variety, just to specify, however not to eliminate any differences should anyone care to ...
14
votes
1answer
613 views

How does one change bow hair?

What are the steps to follow to unmount the hair from a bow and install a new set ? What kind of tools and products do you need beside a new set of bow hair ? How do you measure/adjust the length ...
2
votes
3answers
355 views

Damaged tremolo arm hole in Edge 3 bridge…

just got a new Ibanez that has an Edge 3 trem in it. The difficulty I'm having is that there appears to be a piece of plastic that goes around the circumference of the hole where the arm is inserted ...
4
votes
1answer
582 views

Proper maintenance for classic guitars?

I have had my classic for about two years, and don't do anything to it other than wiping dust off the guitar and replacing the strings when needed(about every month or so). I've had a sponge type of ...
8
votes
4answers
9k views

how does one use or apply lemon oil ?

I have bought a classic guitar for my nephew who is starting classes. The vendor gave me as a gift a little vial of "lemon oil" (translated from the french) saying just quickly something like "it ...
6
votes
2answers
1k views

Insane amounts of fret buzzing on my lower strings

This may have been addressed before, but I can't really find a thread that targets this problem. Whenever I play on my low B, E, or A string between open and fifth fret inclusive, it always buzzes ...
5
votes
3answers
174 views

Is it a bad idea to attach my strap just above the nut?

This question is mainly for my banjo but it seems to apply to my guitar as well. For me it is most comfortable to have the left end of the strap attached to just above the nut on the neck. Is this a ...
5
votes
3answers
5k views

Switching my strings from 10's to 9's - am I in for more fret buzz?

So, I'm playing an Agile 200 Les Paul copy (tune o matic bridge). I've had 10's on it and sadly it has some fret buzz. I recently got it set up to eliminate the buzz and the tech got it pretty close. ...
6
votes
6answers
2k views

Will steel strings wear out my nickel frets ?

I have bought some coated strings because I wanted to try that out. After my purchase I noticed that the package says the uncoated strings are stainless steel. Since my frets are made out of nickel ...
4
votes
2answers
3k views

Is it safe to use guitar polish everywhere on the guitar?

I have owned my first electric guitar for half a year and have only been cleaning it with a damp cloth (without any cleaning agent). Since I'm going to change strings, I think it might be a good time ...
6
votes
6answers
1k views

Any issues with restringing a right-handed ukelele to be left-handed?

I know that you wouldn't necessarily jump on doing this on a guitar, but I'm wondering on a fairly inexpensive ukelele if the strings could be reversed without issue.
5
votes
5answers
11k views

What are the repercussions of using really thick gauge strings on my electric guitar?

I have a Jackson King V JS32T electric guitar in blue, see the linked text for specs and the look of it. Anyway, it came with 0.09-0.42 strings and I've been using 0.13-0.56's on it for a little ...
10
votes
8answers
6k views

How can I stop my electric guitar strings from rusting so quickly?

I suffer from hyperhyrdosis which means my hands sweat quite a lot. The problem is that because of this my electric guitar strings seem to rust quite quickly because of this. Is there anything I can ...
6
votes
4answers
69 views

Should I worry about this strap pin?

I recently bought a Fender Stratocaster that came stock with Schaller straplocks. This is great, because I pretty much always play standing. In shows, I jump around and do all the tricks in the book. ...
3
votes
3answers
3k views

How do you access the electronics on a hollow-body electric guitars ?

Some models of electric hollow-body / electric arch-top guitars do not have seem to have any kind of access to the electronics (switches, pots, caps, wiring) beside the "f" shaped sound holes. I ...
7
votes
1answer
2k views

12-string acoustic guitar - how do nut and saddle materials affect tone?

I'm doing some work on a 12-string acoustic guitar, and am planning to replace the nut and saddle. I need to raise the action a little bit for the E and B strings, and also want to change to a ...
7
votes
0answers
235 views

How to properly store valuable guitars?

What are the general guidelines when storing a collectors, very nice guitar (special woods, etc.), or one you value greatly? You will find humidity control systems in place at stores with "acoustic ...
10
votes
2answers
448 views

Dealing with sharp fret ends

Continuing on my quest to subjugate this cheap bass I picked up in to the realm of "actually useful instrument" I've got a question about taming sharp fret ends. This bass, it has a lot of them. After ...
10
votes
3answers
5k views

Lowering the action on a bass guitar

I have obtained a rather cheap P-bass imitation bass and, while it plays well in the lower register, about the 9th fret the action starts to rise and after the 12th fret it's in to the "wow, this ...
14
votes
7answers
3k views

How do I properly stretch my newly strung strings?

I came across this string stretcher device. It's called The Stretcha. It claims to properly and evenly stretch new strings and maintain tuning. I never really made a point to properly stretch ...
5
votes
7answers
785 views

What to have in mind when traveling by plane with my guitar?

I have to travel by plane to another country in a few months, and I want to bring my guitar with me. I have doubts with what should I do to ensure that my guitar arrives safe and in perfect condition. ...
7
votes
3answers
10k views

Should a Floyd Rose bridge be parallel to the body of the guitar?

I've read before that a Floyd Rose bridge should be parallel to the body of the guitar. This is an image of the bridge on my guitar: You can see that the left side of the appears to be a little ...