7
votes
3answers
197 views

What is the difference between an amp and a head?

At the moment I currently only use a basic guitar amp, but a few of my friends have 'heads' on top of their amps. What is the purpose of these? What do they do that the amp doesn't do?
7
votes
4answers
310 views

How to connect a line signal to a guitar amp?

My Laney Lv300 Tube Fusion Combo amp, doesn't have a Line-In, as such. It merely has one "Input" on the front, for the guitar and a pair of FX sockets, as an FX Loop (FX Send and FX Return). It also ...
7
votes
3answers
780 views

Why do people place amps on top of things?

In a lot of gigs I've played, I have noticed that they have placed the amplifier speaker cab (usually just the bass amp) on top of a chair or a stool or something, so as not to be on the ground. What ...
0
votes
3answers
1k views

if i connect audio interface line out to guitar amplifier guitar input can it damage the audio interfae

Generally audio interface line out is connected to studio monintor speakers. Since i don't have any i was wondering i could use my marshall 15watt guitar amp as speakers. if i connect audio interface ...
2
votes
3answers
4k views

How to connect a 16 ohm and an 8 ohm cabinet to the same amp head

I just brought home a Peavey JSX 4x12 cabinet and realized that it's 16 ohms while my other cabinet (Marshall 4x12) is 8 ohms. The JSX has two jacks in parallel for chaining while the Marshall has a ...
1
vote
3answers
481 views

Speaker clipping when bass guitar controls turned up, but not when amplifier controls turned up to same volume

I've noticed if I have my bass guitar's volume and bass EQ knobs turned all the way up, it sounds like the speaker is clipping. If I then turn the volume and bass down on the guitar while turning the ...
3
votes
2answers
2k views

150w 8ohm speaker on 300w 4ohm channel - have I done my maths right?

I'm building a DIY frankenamp. It currently consists of a speaker cab with a 15 inch, 150w @ 8ohms celestion truvox red label, which is plugged into one channel of a Skytec pro600 stereo power amp. ...
1
vote
3answers
4k views

Turning off my monitors makes loud popping noise

I've been told that my turning down the channels on my mixer before turning off my monitors, I can prevent the loud popping noise they make, which will damage the speakers in the long run. However, I ...
1
vote
1answer
1k views

How can I connect speakers to my POD 2.0 and get a good sound?

I like to practice at home with my electric guitar, but I have to keep the volume low, so I usually use headphones connected to my P.O.D. 2.0 guitar direct box. But sometimes I'd prefer to use ...