2

Every time I have to replace strings on my electric guitar (whether it's because the string broke or just because they're starting to sound bad), my tremolo action always sinks really low into the cavity. A few years ago I found an effective way to fix this, but I've forgotten the method and cannot find the article I read.

question: How can I raise the tremolo action back up again? The end closest to the pickups is at normal height, but the other end is sunken way down into the cavity.

my guitar: Ibanez RG Prestige (I do not know which model exactly) with an Edge-Pro tremolo system

Improve this question
2
  • 1
    Sounds like you might need to adjust the springs that counter the string tension. Never used an Edge-Pro though so I don't have any specific information. Floyd Rose should be similar: youtube.com/watch?v=5yrAckQ4HvE
    – charlie
    Oct 15, 2014 at 19:11
  • If you use the same gauge of strings, the tension will bring the trem back up to roughly where it was. Don't worry about it dropping into the body when the strings are off - that's fine. It will come back up once you tighten the strings.
    – Doktor Mayhem ♦
    Oct 22, 2014 at 12:19

1 Answer 1

Reset to default
3

From the Ibanez technical forum:

If the tremolo is not level with the body, and the rear edge is lower than the front...

...loosen the screws on the spring claw to reduce tension...

...and return to the correct alignment

The tremolo is held in position by two opposing tensions - from the strings, and from the springs in the rear cavity. You can adjust the position of the spring claw, by loosening and tightening the highlighted screws, to get the correct balance.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.