2

I am building a homemade xylophone out of copper pipes. I want it to be accurate if I measure it for 5 seconds and take the average pitch. For my F4 pipe for example, when I do this, it tends to go really high (somewhere around A7 usually) and then go to around 340 Hz, which is closer to the frequency I want, but then it will alternate between 341 and 0 Hz, so my average frequency gets really skewed. Any ideas as to why? My bars are mounted at their nodes, and I've tried using a hard and softer homemade mallet. Thanks!

  • 2
    How are you measuring the pitch? Also, weird that you're getting 0 Hz. I wonder if some vibrations are phase cancelling. Are these cylindrical lengths of pipe or flat pieces cut from pipes? – luser droog Nov 26 '18 at 0:36
  • @luserdroog I'm using Google Science Journal and also the pipes are hollow cylinders (I think they're originally used for plumbing). Also I thought the 0 Hz could just be because of the note dying out and getting too quiet for my phone to pick up. – o.ma19 Nov 26 '18 at 2:35
  • Am I reading your post correctly? The pipe that should be F4 (349 Hz) sometimes registers as A7 (3,520 Hz?) – Michael Curtis Nov 26 '18 at 19:04
  • @MichaelCurtis Well, kind of. The pipe that should be F4 registers as A7 on my device at first, then the pitch will bounce between the correct frequency and other frequencies, usually 0 Hz. – o.ma19 Nov 27 '18 at 1:09
  • A xylophone has wooden bars. A glockenspiel has metal bars. So isn't this a glockenspiel or some other type of metallophone rather than a xylophone? – Brian THOMAS Nov 27 '18 at 12:44
5

The main problem is your measurement, not necessarily the instrument. The Xylophone creates a lot of different frequencys. Their relative strength will change over time and will confuse most measuring devices. The only instrument I know of that does a good enough job is ears. You have to listen to the instrument and decide whether it has a good sound and is in tune. Ideally you need to listen a few meters away, and in different directions. Some of the "noise" frequencys gets less noticeable a bit away from the instrument.

I suggest you do a goodle search on "xylophone frequency spectrum", people have been looking into this already.

If you want to change the sound or timbre of the instrument you might want to experiment with different materials, different geometries, perhaps drilling holes or adding dampening or resonant materials. This might allow you to deaden all but the fundamental frequencys, but then it will not sound like a xylophone anymore. But, please, do go ahead and experiment, it is great fun. /Gunnar

  • I think It's going to be hard to listen to a test instrument from a few meters away as you strike it. – Dekkadeci Dec 15 '18 at 16:41
  • Unless you have a friend? – ghellquist Dec 15 '18 at 16:51

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.