23

This drawing should do:

Straight bow hairs

These are the hairs of a brand new bow. Straight, clean, etc.

I noticed this:

Straight bow hairs with one loose hair

As you can see, it seems like a certain hair is a bit loose.

  • Is this bad? (I.e., does it affect performance, produced sound, etc.)
  • Should I try to remove/cut it? Or perhaps I should change the whole hair set in the bow?
Improve this question
13

A loose hair won't vibrate the string in any useful way, and it may catch at unwanted moments.

Remove it, just as you would a broken hair.

Improve this answer
4
  • Simply remove it! – Manoochehr Jan 11 '13 at 9:46
  • 2
    So I just cut it off from both sides with, say, scissors or is there a more technical way to do it? XD – Omega Jan 11 '13 at 19:35
  • 2
    I use a very sharp knife. – Doktor Mayhem♦ Jan 11 '13 at 22:12
  • I just pull it and snap it off. Usually the ends come out cleanly. Edit: But after reading some of the answers I realize it's not a great thing to do. Will cut from now on. – talonx Jun 16 '20 at 7:59
12

The guy who rehairs my bows once advised me that I shouldn't completely pluck out the hair, but to leave a little bit on both ends. This is so that the other hairs don't become loose and fall out. He said it's not generally a problem since most people don't break ridiculous amounts of hair, but it makes it easier to rehair your bow and is best for your bow in the long run. Also, I've found that wrapping the hair around the tip of the bow then pulling effectively leaves a little at the end.

Improve this answer
5

If you just have one or two, remove it. The best approach is to cut it at the loose bit, then pull the hair away from the rest of the bow and cut it carefully at both ends, right up against the frog and the tip.

You can do this many times before the bow needs restrung.

Remember, using rosin diligently reduces breakages, thus increasing the lifespan of your bow.

Improve this answer
1
  • 1
    Is the rosin thing true? My intuition is that the bow is more slippy and thus less likely to snag with zero rosin (though you clearly wouldn't want to play it that way as it sounds awful) – dumbledad Jun 2 '15 at 11:34
1

I have always been told to cut broken hairs off a bow (such as with scissors) rather than pull them out, as that will make the bow hair last longer before you need it replaced (that way the rest of the hair is less likely to fall out). I play at an advanced level and was recently told I should have my bow rehaired at least once a year. I doubt you need to rehair it that often (I'm studying violin in school so I play it a lot) but it is something to consider, but make sure you go to someone good because I went to a very mainstream violin shop and he did a terrible job and many of my bow hairs looked like that. Now I only go to people that my peers or teachers go to and have good experiences with. If your whole bow's hair was a mess like mine was you would have to have someone else just completely redo it.

I have not heard the thing about rosin so I don't know anything about that.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.