Skip to main content

Questions tagged [action]

The calibrated distance between the open strings of a chordophone and the surface of the fingerboard or frets.

Filter by
Sorted by
Tagged with
2 votes
1 answer
223 views

Neck relief issue, fret buzzing, truss rod loosened to the limit

I pieced together an electric guitar from a DIY kit, after two months I still have a problem with the neck and the truss-rod, when I measure the neck straightness by pressing the first and last fret ...
2 votes
1 answer
104 views

Adjusting Floyd Rose Action - Bridge is Lower On Treble Side

I am adjusting the action on my Floyd Rose Special. In order to get the action low enough on the treble side - I had to lower it a bit. Is it normal that the treble side of the tremolo is lower/...
10 votes
5 answers
8k views

On instruments that use frets, where's the best spot to press a string on, in order to minimize hand fatigue and potential for injuries?

I know this question sounds completely subjective at first sight, it even triggered the automatic "The question you're asking appears subjective and is likely to be closed" alarm, but please read ...
-2 votes
1 answer
279 views

Is it technically possible to play Chopin`s op. 10 No 1 etude at 176 bpm on Casio PX-160 piano?

Is it technically possible to play Chopin`s op. 10 No 1 etude at 176 bpm on Casio PX-160 piano?
0 votes
4 answers
1k views

Can my guitar action be lowered further, or is it already too low?

I have gotten a lot better at bending, so I stopped questioning the action on my guitar for a while. But now I feel like although it is good at the lower frets; at the higher frets it seems very high ...
4 votes
1 answer
726 views

My B string on my bass keeps hitting the pickup

I went to record bass for my band a while ago and in some fills or moments I use the B string on my 5 string Sire Bass. Sometimes though, the Low B accidentally hits the pickup which makes a loud ...
3 votes
3 answers
2k views

Floyd rose bridge leaning to the treble side

I've decided to change my strings on my guitar, and when I finally was done with setting up the springs to make the bridge parallel to the body, I wanted to make the action lower. I noticed that it ...
5 votes
6 answers
760 views

Moving short violin bridge towards fingerboard

My violin bridge is slightly too short; if I place it between the f-hole notches as it should be, action becomes too low. I normally use heavy gauge strings to partially compensate for lost tension. ...
1 vote
2 answers
818 views

String Buzz and Dead Notes on Squier Strat

I am new to guitar and bought a new Squier Strat as my first guitar. I changed the strings myself to 008's a couple months in, and I think that may have caused some of the problems that followed ...
0 votes
2 answers
3k views

Floyd Rose action way too low

I changed strings and now the bridge is tilted back abd the strings are touching the neck. I've tried turning the screws on the bridge base, but it makes no difference. Do I need a need base plate or ...
6 votes
4 answers
31k views

Switching my strings from 10's to 9's - am I in for more fret buzz?

So, I'm playing an Agile 200 Les Paul copy (tune o matic bridge). I've had 10's on it and sadly it has some fret buzz. I recently got it set up to eliminate the buzz and the tech got it pretty close. ...
3 votes
1 answer
1k views

Problems with playing high notes (17-20th fret on e-string)

I have a problem that when I play a note on the e string (the tiniest one) on the 17th to 20th fret, I noticed that the same notes were repeated and starting in the 21st fret, the notes were fine ...
2 votes
1 answer
294 views

Clunking/clacking bass

So I have a Fender Jazz Bass and I was playing it the other day and once I got to the 5th fret there was buzzing, and past the 5th fret (depending on what I was doing) there was severe, sort of, ...
3 votes
4 answers
4k views

How can I lower a plastic acoustic guitar saddle?

I got an acoustic steel-string guitar, the nut's height is perfect. Now I want to lower my saddle. It's made of plastic – a bone synthetic for making sure – which I think it's a bit hard to get it ...
2 votes
2 answers
61 views

How do I keep my guitar in tune with out affecting the action?

I recently changed the strings on my strat from 9s to 10s. I play with my fingers and not a pick, so lighter gauge strings for me are hard to pluck because they bend so easily when I pull on them, ...
5 votes
3 answers
24k views

Acoustic Guitar | How to adjust the gap between the strings and the fret board

I have a 2 year old acoustic guitar . Over the period of time there's a huge gap that has appeared between the higher frets and the strings. What has caused this gap? and How do i fix this.
2 votes
1 answer
141 views

How does the action (distance between fret and string) of a guitar affect the tone / sound / timbre?

When talking with or reading / watching about professionals and their setups (acoustic instruments in particular), I found that there's a heavy tendency for using higher actions, in contrast with non-...
2 votes
1 answer
772 views

Do I have a guitar with high action?

I am a beginner at guitar. Recently I took my guitar to the store to get its action fixed.But now I see that there is no difference in the actions. I can fit two 2-mm coins in the 12th fret.I could ...
2 votes
3 answers
316 views

Electric Guitar Setup For A Newbie

I have always wanted to learn how to play guitar, especially Electric. I had a birthday recently and my wife bought me a super cheap setup from eBay. I know there are a lot of reasons to use a more ...
7 votes
4 answers
7k views

How to decide what kind of truss rod wrench to buy?

I have a walden guitar which has a truss rod. It's action was high and I gave it to a music shop to adjust. They adjusted the neck but now the frets are buzzing a bit. Also I think that the action ...
2 votes
1 answer
1k views

Standard Jazzmaster HH bridge/saddle height adjustment

The Fender Standard Jazzmaster HH is a modern hybrid, with a few differences compared to the classic design: the tailpiece has been moved closer to the bridge, and the saddles are a sort of Jazzmaster/...
0 votes
3 answers
203 views

Can a well regulated piano be incompatible with a sufficiently fast/soft song?

I play an upright piano with particularly heavy keys, and whenever I'm learning a very fast song (e.g. parts of Clementi Op.36 No.5) I wonder if even the composer couldn't have played it on my piano ...
5 votes
1 answer
524 views

Piano action too stiff after tuning, what's happened?

My new second hand schimmel 112 upright had its first tune three weeks ago. We bought it 8 weeks ago, let it rest and acclimatise then had it tuned with a mini service. The piano is 25yo and its last ...
13 votes
4 answers
31k views

Lowering the action on a bass guitar

I have obtained a rather cheap P-bass imitation bass and, while it plays well in the lower register, about the 9th fret the action starts to rise and after the 12th fret it's in to the "wow, this ...
6 votes
4 answers
3k views

Upright Piano action problems

So I've been playing the piano for about 13 years now and I've noticed the action of my piano getting worse and worse. There are actually several problems: On some keys the amount of force needed to ...
4 votes
4 answers
9k views

What's the effect of playing with high action?

I have guitar, the action is really high. My question is: what's the affect of learning and practicing in high action in the long term? Is this an advantage or not? Is high action something that'll ...
1 vote
2 answers
88 views

How can I lower action on this guitar

Here is the picture of guitar. https://photos.app.goo.gl/kRjPwrUCL5ad5gT46 It is a hovner 185 guitar, how do I lower the action on this guitar?
5 votes
5 answers
10k views

Truss rod adjustment had no noticable effect

Today I adjusted the truss rod on my guitar, because the action was quite high and I found it difficult to play. I progressed slowly, and did 1/8 turns, but after each turn I had not noticed anything ...
1 vote
1 answer
1k views

High action on higher fret on my steel acoustic guitar

It's been 2 years since the last time I played guitar. I tried to play again this morning and something feels off. I felt sore on my wrist when trying to play barre chords for just a few strums. I don'...
2 votes
3 answers
2k views

String gauge switching without truss rod

My acoustic guitar has no truss rod and all this time I've been using .12-.53 gauge strings, and until now it's still that gauge, I've bought a .10-.48 but i haven't switched out the strings yet, but ...
9 votes
2 answers
2k views

Can a stiff piano action be lightened?

I have a grand piano with an extremely heavy/stiff action. Is it possible to lighten the action without completely rebuilding it? Is this something a professional piano tuner would do or would I have ...
13 votes
4 answers
22k views

What is the downside of ultra-low action?

I understand that low action on a guitar makes it easier to play. (See answers to this question for more on action and truss rods). I've never understood why all guitars aren't set-up with action as ...
4 votes
3 answers
4k views

tight truss rod

I recently got my hands on a used schecter km6 guitar. It played great, except for that the action was higher than i like it. I checked the relief in the neck (fretted the 1st and 17th fret, measured ...
3 votes
3 answers
18k views

I think my guitar strings are wound too tight and I can't play barre chords

I'm a beginning guitar player, with a secondhand Yamaha FG-180J I got as a gift. The strings were already wound when I got it. Upon playing it, I had a lot of trouble playing barre chords. The strings ...
2 votes
1 answer
2k views

Ideal action and string gauge for acoustic fingerstyle

I've been playing more and more percussive fingerstyle, and one thing I have trouble with is getting volume when hitting strings with only my left hand, for example like Jon Gomm and others. ...
3 votes
3 answers
3k views

Am I correctly approaching the relationship between string bending and action height?

Mostly self-taught guitar player here, haven't had a lesson in 30 years. Running into particular problems with string bending, and after some google searches, trying to finally come up with a strategy ...
5 votes
1 answer
2k views

When adjusting the neck of an acoustic guitar, what bending might be normal?

Recently I bought a second guitar, before I had for almost 8 years just one guitar and did not noticed that its action was quite high. When I took the guitars of others I often wondered that they ...
2 votes
3 answers
238 views

How to know the action of an acoustic guitar before buying it?

The question is in the title, really. I usually play electric guitar and I'd like to learn some finger style on an acoustic guitar. Many acoustic guitar I tried are much harder to play and I've been ...
9 votes
4 answers
40k views

Is a slight amount of fret buzz acceptable when lowering the action on a guitar

I recently took my Ibanez RG into the shop for new strings (same gauge as original) and asked them to lower the action. It came back with a significant amount of fret buzz (pretty much all over the ...
3 votes
3 answers
9k views

Fret Buzz on specific areas

I have a Jackson Ke5Fr Kelly, I mainly used it on .09 string gauge with standadd tuning but last couple of months it was .10's in Whole-Step Down tuning. Now, I turned back to .09's and standard ...
8 votes
2 answers
7k views

Insane amounts of fret buzzing on my lower strings

This may have been addressed before, but I can't really find a thread that targets this problem. Whenever I play on my low B, E, or A string between open and fifth fret inclusive, it always buzzes ...
4 votes
2 answers
62k views

High action VS Low action

Can someone compare between high action and low action on guitar and which one is better , i don't know too much about them.
2 votes
3 answers
4k views

Switching from keyboard to hammered-key digital piano

Ι've been playing 61 keys non-weighted keyboard for 3 years with the sole purpose of learning piano. But as Ι improved, I wanted to learn more and more difficult tracks which included 0th and 6th ...
1 vote
3 answers
1k views

Guitar strings, high action but not touching saddle

I found the action on my acoustic guitar seemed very high and measured it to be >5mm. I read how to lower it and sanded down the saddle. I now have the issue that I sanded so much that the bottom and ...
0 votes
2 answers
191 views

Difference in action between pressed and unpressed strings too much?

When pressing an individual string at lower frets on the fret board, I sometimes miss the string with my pick due to its height in relation to the other strings. In other words, I feel like the ...
4 votes
3 answers
2k views

What is the safest way to raise and lower action and adjust intonation?

I'm worried that taking my strings of every time to check whether the action or intonation is right will make them snap. So what's the safest way to remove new strings so I can change the intonation ...
1 vote
2 answers
354 views

What would (theoretically) cause ESP LTD strats with Floyd Roses to play easier than an MIM Strat?

Well, my beliefs are being challenged again about guitars' ease of playing. I once thought my strat was as good as it got, but no. Amazingly enough, a $250 LTD guitar (along with other similar models, ...
2 votes
1 answer
838 views

Is guitar action affected by tuning?

I am looking at purchasing a nice second hand steel string acoustic guitar in a local music shop. One of the aspects that I really like about the guitar is the string action. When I was trying the ...
3 votes
2 answers
1k views

Is the action of my guitar really high?

Okay, so I bought an acoustic a few months ago and now I have calluses on my fingertips, but I still get deep trenches in my fingertips if I play for like an hour or so. Right now I'm trying to learn ...
5 votes
2 answers
4k views

Floyd Rose string tension and action question

I've been playing for quite some time, but have always owned and played non-trem guitars. These days, I'm in a kind of band where some whammy is of great use, so I picked up a Jackson Warrior with a ...