I got a standard American strat from 2015. When I tighten the trem bar, the bar stops tightening right over the strings. However when I loosen it, one turn and it flops around all over the place. What could I do?
3 Answers
I see two courses of action...
You could just take the damn thing off altogether, as I did 40 years ago ;-) or
Get a roll of plumber's PTFE tape from a hardware/DIY store & wrap it round the thread until you achieve just the right resistance.
PTFE is "Teflon" so it will never stick or jam. It is so thin you could probably get 5 - 10 wraps before it's too thick to screw in, so you will have a lot of room for fine adjustment.
Added bonus, it will never leak ;-)
For the plumbing junkies out there, PTFE is polytetrafluoroethylene
After comments:
Don't use any kind of sticky tape. It will come back to haunt you.
There's a really specific reason to use PTFE, & it's because it never changes state, doesn't get sticky, doesn't dry out.
-
-
1#2 is a clever solution, and I don't know why I never thought of it. Probably because I too settled on #1 long ago ;)– user39614Commented Jun 2, 2019 at 16:22
-
I settled on #1 but as the son of a plumber, #2 is never too far away in my head for 'threaded things'.– TetsujinCommented Jun 2, 2019 at 16:24
-
1holy crap tape worked. it wasnt teflon, it was this matte scotch tape but it works exactly how i wanted it to– Juno CCommented Jun 3, 2019 at 8:00
-
If yours has a blind hole - which doesn't go all the way through - you can use a small coil spring - 5mm or 6mm - depending on the diameter of the vib. arm. It will produce tension as it gets tightened onto. Or even a small cylinder of rubber in the hole. It is about the only part of Strats that, in my opinion,, never got sorted. All the ones I've used had a terrible fit between the thread in the vib. and the thread on the bar itself. If I played Strats regularly, I reckon I'd have put helicoils in.
-
Probably different for a one-off on a guitar, but I used to work with a lot of aluminium structures with helicoils; great while they work, but if anyone ever cross-threads one, you rupture the helicoil & end up with a stuck bolt in a spinning structure that then needs to be drilled or sawn out.– TetsujinCommented Jun 2, 2019 at 10:12
-
@Tetsujin - true - but if one crossthreads the original bridge, it's just as problematic. Which is probably why the thread is so sloppy - to stop that happening..!– TimCommented Jun 2, 2019 at 11:13
-
Very probably. tbh, I't's not a problem I've really had to suffer. I think I started removing the trem & locking the bridge down in the 80's, about the same time everybody started getting into those huge swoop-dives; I decided enough was enough ;)– TetsujinCommented Jun 2, 2019 at 11:18
-
1Although it was probably lost on a guitar that old, most strats come with that spring in a plastic baggie in the case candy.– PeteConCommented Jun 19, 2019 at 13:11
-
1@PeteCon - interesting. Never having had a new Strat, I didn't know. But probably lost or eaten by the dog in the first five minutes!– TimCommented Jun 19, 2019 at 13:31
I haven't had a strat in a few years, but if memory serves me I had a similar problem. On the Stew Mac website, I purchased a small spring to go into the assembly. It provided enough resistance to position it the way I liked. I hope that helps.