1

Just recently, I finished building a guitar from a kit I had bought. It seemd pretty straight forward, and everything turned out fine, just with one issue. When I play an open string, the tuning is correct, but one I play any fretted notes between the first and 8th frets, all of the notes are too high a pitch.

I at first thought that this was an intonation issue, but I realized that when I play the 12 fret on any string, it goes back to being in pitch.

It's sorta like the opposite of what you would expect to see, the lower frets are too high a pitch, but the higher frets (and open strings) are fine.

Is there any way I can fix this without taking it to the shop?

Improve this question
3
  • Please provide a LOT more info: electric or acoustic? Did you set the bridge length (particularly for electric) so the first harmonic matches the fret location?
    – Carl Witthoft
    Commented May 9, 2015 at 12:51
  • Sounds like a nut issue, either too high or misplaced. How high are the strings over, say, the 3rd fret?
    – leftaroundabout
    Commented May 9, 2015 at 13:52
  • @Carl Witthoft It is an electric with the common telecaster bridge and body. I did make sure sure the first harmonic matches the 12th fret (if that answers your second question.) The string is just less then a quarter inch above the fretboard at the third fret
    – Rex302
    Commented May 9, 2015 at 15:41

1 Answer 1

Reset to default
3

Not sure how you measured your action, but, according to your comment, a quarter inch is a lot. So I guess your action is much too high, which means that when you press down the string on the first several frets you actually stretch the string and raise its pitch.

I can think of two causes for this: the neck could be too concave, which can be fixed by adjusting the truss rod (turn it clockwise). The other problem could be that the nut is too high. Either it is positioned wrongly or the slots are cut too high. Check this setup guide for more information on string action and on how to adjust the truss rod.

Improve this answer
3
  • Ok, I adjusted the trust rod, which seemed to help. The strings are around 1/8th of an inch above the fretboard now, but it still hasn't seemed to completely fix the problem. I think I will bring it in for service because I am not 100% sure on what I'm doing. Thanks for the help though
    – Rex302
    Commented May 9, 2015 at 18:09
  • @Rex302: You could check if the nut is too high or if the nut slots are not deep enough, but if you don't have a lot of experience it's probably a good idea to have a luthier have a look at it. Good luck!
    – Matt L.
    Commented May 9, 2015 at 18:18
  • Remember, no more than a 1/4 turn of the truss rod in 24 hours,
    – Jay Skyler
    Commented May 10, 2015 at 7:55

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.